PDA

View Full Version : front end troubles help please

zbm22
11-06-2009, 01:37 PM
ok so me and my boy were driving last night i flipped a bitch and got on my car till like 4th gear slowed down to like 45. then went hit second gear it pulled for a seconded then the hole front end started shaking violently, and was pulling my car to the right extremly hard. so here is my question i check both driver and passenger side everything is tight and axels are fine i cant find out what is wrong maybe someone else has experienced this. and my car is a 95 integra.
Dead Bird
11-06-2009, 01:39 PM
what happened last time when it wouldn't go anywhere?
was the dif bad? or axle?
Dead Bird
11-06-2009, 01:40 PM
text me, i gotta go to work
Jason.AZ1
11-06-2009, 01:46 PM
Not the tranny, just got replace the axle its free replacement anyways
zbm22
11-06-2009, 02:22 PM
it only did it that one time thats it hasnt done it again its so damn strange i dont understand it
fmx_dbc
11-06-2009, 02:27 PM
motor mount?
Dead Bird
11-06-2009, 04:37 PM
from what he said over the phone, either something popped out of place and back in, but i can't for the life of me figure what it was, or he ran something over that locked up the front right wheel for a few seconds
jordanherrera07
11-06-2009, 05:13 PM
thats fukin weird that hapened once to me in my 92 integra , did it once after i put a fresh swap in it , and after that the car ran like a champ.
Jermey1
11-07-2009, 10:44 PM
I think your car was scarred of that si you were running down lol!
zbm22
11-08-2009, 11:17 AM
I think your car was scarred of that si you were running down lol! maybe it was but deff not scared of your car lol jk jk
24/7VTEC!!!!
11-08-2009, 11:23 AM
axle bearings popped out of place?
FranktheTank
11-08-2009, 12:10 PM
from what he said over the phone, either something popped out of place and back in, but i can't for the life of me figure what it was, or he ran something over that locked up the front right wheel for a few seconds

From what you said i would say his tranny or drivers side mount is bad, got wheel hop when he got on it, which made the engine move out of place causing on of the axles to bind up?

Possiblitly but i dont know, just throwing it out there
Jermey1
11-08-2009, 02:42 PM
maybe it was but deff not scared of your car lol jk jk

WE WILL SEE!:this-guy_2: