advert
12-11-2011, 02:00 PM
Some of you guys might like this, i have been working on it for about a year now as money comes in. I built it from the ground up and its a lot cheaper then buying a kit. all together i have maybe 5k into the build.
i built the frame out of 3 inch square .120 wall tube, and 2 inch .120 wall square.
the slides roll on 1/4 inch cold rolled. and the grates are sheered 16 gauge.
I used the slides and gears from www.cncroutherparts.com
its a rack and pinon set up with a belt drive reduction.
for the z i used linear slides from imsrv.com
for electronics i used www.candcnc.com package with DTHC.
Plasma i used a miller spectrum 875.
I had some of the parts to complete it cut out on a water jet and a laser then welded them as needed.
as of right now the machine works and performs perfect just need some finish touches (wire tracks and little stuff)
It was nice to be able to use the machine its self to make parts to finish it.
http://img140.imageshack.us/img140/416/imag0317w.jpg
http://img835.imageshack.us/img835/1407/imag0319x.jpg
http://img840.imageshack.us/img840/5963/imag0320to.jpg
http://img685.imageshack.us/img685/1228/imag0351su.jpg
http://img861.imageshack.us/img861/7057/imag0352c.jpg
http://img15.imageshack.us/img15/6158/imag0353eb.jpg
http://img831.imageshack.us/img831/296/imag0354zh.jpg
http://img694.imageshack.us/img694/9770/imag0355k.jpg
http://img221.imageshack.us/img221/910/imag0356uq.jpg
i built the frame out of 3 inch square .120 wall tube, and 2 inch .120 wall square.
the slides roll on 1/4 inch cold rolled. and the grates are sheered 16 gauge.
I used the slides and gears from www.cncroutherparts.com
its a rack and pinon set up with a belt drive reduction.
for the z i used linear slides from imsrv.com
for electronics i used www.candcnc.com package with DTHC.
Plasma i used a miller spectrum 875.
I had some of the parts to complete it cut out on a water jet and a laser then welded them as needed.
as of right now the machine works and performs perfect just need some finish touches (wire tracks and little stuff)
It was nice to be able to use the machine its self to make parts to finish it.
http://img140.imageshack.us/img140/416/imag0317w.jpg
http://img835.imageshack.us/img835/1407/imag0319x.jpg
http://img840.imageshack.us/img840/5963/imag0320to.jpg
http://img685.imageshack.us/img685/1228/imag0351su.jpg
http://img861.imageshack.us/img861/7057/imag0352c.jpg
http://img15.imageshack.us/img15/6158/imag0353eb.jpg
http://img831.imageshack.us/img831/296/imag0354zh.jpg
http://img694.imageshack.us/img694/9770/imag0355k.jpg
http://img221.imageshack.us/img221/910/imag0356uq.jpg