k24 k20 hybrid

[GroceryStore_ninja]

what pover can be expexted fro a k24 with k20a head and pistons

[AZ93Civic]

good old "K" Power

[YewllowDA]

im not exposed to "K"'s yet

[hawaii_DA6]

You have a ton of research to do yet.

K24a2 bottoms mated w/ a type S or Type R head will manifest insane all motor power and torque numbers.

but you are jumping in to a whole new world of building. the K series engines are a lot more intricate than B series powerplants, and the matching of right components and parts are very important. You need to research some before you jump into this.

for your info, some rods/ pistons, cannot even be used with that hybrid set-up.

[no2psi]

what pover can be expexted fro a k24 with k20a head and pistons

It depends...how much compression, what cams, what intake, who built the motor
who tuned it. etc...
Stock bottom end a with stock head, bolt ons. around 220whp and 185foot lb. dyno jet numbers, higher if you use a dynapack.

Now if I built it for myself.....................

[GroceryStore_ninja]

ive got 4 months till i start to buy the parts. so i have a little time to do the research. im looking for any help with ideas for the build i was just going to put a k20A in but i decided that a k24 setup like this would be much more cost effictive and may eventualy spring for the brian crower k24 stroker kit trying to get atleat 11:1 12:1 comp i knw they are about 1 mm differance in bore might have to get aftermarket pistons just looking for advice and doing research

Help a bro out

[taggart_lumpy]

depends.....

[GroceryStore_ninja]

Dose any one have any resources i can check out

[K20 PWR]

www.k20a.org

[JustinD]

here is the dyno from my built k24 motor. (280whp & 217 wtq )

http://www.azht.net/forum/showthread.php?t=16042

87.5mm bore, 12.5:1 compression, IPS KME cams, TWM Itb's ....