Swap Question

[REDREX]

I Got A 94 Civic With A B16a In It But The Frame Is Messed Up Cuz It Was In A Accident..so What I Want To Do Is Put It In My 96 Civic Ex Well The Question Is Will It Bolt Up Without Any Problem Or Do I Need Motor Mounts

[projectaccord]

youll need b series mounts. oem si mounts should fit right in there i believe. youll probably need a shift linkage too. when we put a geezer in my buddys ek, we had to extend to exhaust too. hopefully this helps you out a little.

[REDREX]

Can I Use The Mounts In My 92 Civic

[projectaccord]

they have to be ek b series mounts bro.

[projectaccord]

oh yeah, if the motor setup is obd1, youll probably have to get an obd2-obd1 jumper harness also.

[Vtec_Nation]

you could keep the motor mounts the same just change the rear motormount bracket to a B series and driver side bracket. the driver side bracket is the one bolted to the block. you could keep the driver side mount and passengr side mount just change the bracket

[my99ctr]

if your motor is obd1 you will also need an obd2a dizzy and an obd2a alt as for the mounts you can use the stock mounts that are in ur ek all you need is a rear t bracket for an SI as for the shift linkage that u used with the b-series in ur eg i'm not 100% but it should be ok an depending if your exhaust is oe or aftermarket you may not need to mess with it

[my99ctr]

they have to be ek b series mounts bro.

when it comes to the ek no they don't have to b b-series all he would need is the b-series rear t bracket assuming his car is manual if his car is auto he will also need a trans mount unless he is planning to do an auto b-series swap

[my99ctr]

oh yeah, if the motor setup is obd1, youll probably have to get an obd2-obd1 jumper harness also.

only if he wants to run the car in obd1 like if he were to use hondata if not he can run a 99-00 si ecu or a 96up teg ecu