distributer problems

[enjuku]

i iam doing a jdm h22 swap into my 94 ls accord and i need help with the distributer wiring. The question is how do i wire the external distributer harness for the internal h22 distributer. Which would be the three wires on the external harness. Any help would be great.

[JDMjames]

On the external coil you will only use 2 out of the wires. There should be a fat wires possibly a black with yellow strip, that wire will be used and one of skinny wires will be used. I can't recall what color it is.

It is a lot easier that it sounds.

GL. There is a lot of info on this all over the net. give it a search.

[VTECin5th]

Make a jumper and plug it into the (coil) harness, tape the jumper in place and then re-tape it all again so it doesn't move. (After you're sure the car starts/runs)
This is good, in case that distributor ever goes out you can use a USDM coil and distributor later.