Wtb Frontmount Intercooler

[hittin-vtec]

HEY WHATS UP IM LOOKIN FOR A FRONTMOUNT INTERCOOLER WITH ALL THE PIPING
I HAVE CASH IN HAND HIT ME UP WITH A PM IF YOU HAVE WHAT IM LOOKIN FOR

THXS :clapper:

[Stealthy]

I have a FMIC, but no piping. I only want like $50 obo.. lmk.

[hittin-vtec]

naw dude i need on with piping its goin on my 92 awd eclispe

[Lilrob]

wrong section btw and good luck findin the piping here for that

AZHT= Arizona Honda Tech

[Stealthy]

naw dude i need on with piping its goin on my 92 awd eclispe
Oh, ok.. GL finding that on a Honda board man.
wrong section btw and good luck findin the piping here for that

AZHT= Arizona Honda Tech

It's Arizona Honda Tuners, I do believe...:blunt:

[Lilrob]

hah same thing lol still wrong place to look

[Stealthy]

lol... tru

[hittin-vtec]

its just a intercooler it will fit on my eclipse i have one off a honda on it right now

[hittin-vtec]

bump

[Stealthy]

its just a intercooler it will fit on my eclipse i have one off a honda on it right now

Right, which is why I offered you one.. However, you said you needed the piping with it, and you most likely wont find that here, cause most people have Honda piping, NOT Mitsubishi. And that part ISN'T the same.. So like I said, good luck finding it.. I hope it works out.

[RHDDonnieee]

i have one with two charge pipes that will work with eclipse

[Stealthy]

i have one with two charge pipes that will work with eclipse

There ya go, buy this guys stuff.. Good dude..

[RHDDonnieee]

There ya go, buy this guys stuff.. Good dude..

thx nig

[hittin-vtec]

hey rhddonnie how much for the intercooler

[hittin-vtec]

hey stealth si will u take $40 for the intercooler pm me

[RHDDonnieee]

hey rhddonnie how much for the intercooler

just intercooler 75$

[BADCHKN]

hey stealth si will u take $40 for the intercooler pm me

lol you worried about 10 bucks?

[hittin-vtec]

all i have is $40

[hittin-vtec]

rhddonnie how much with piping

[Rufus]

I need one too

[FabricatorX]

I have a bunch of piping. It comes in the form of 90* and 180* bends. I then take it and cut what I need and weld it together. This is my job. Call me ;) unless your poor, then gl ;)