ek wire tuck

[Bodykit]

ok so I've done a small one on my old eg which included headlights, fuse box and just tucking the harness away some. but I've seen way more done on an ek, so I'm wanting to do one on mine when I get the stuff to do it, I'd pay someone but don't have the money so figured I'd try again, so pretty much what I'm wondering is is there a big difference on doin one in an eg hatch and an ek hatch? more or less work and if possible maybe someone can get me a link or something on steps to do a FULL wire tuck? thx guys.

[IntegraDA]

take a look at my tuck progress thread in the DA section. I have quite a few pics that can give you ideas on where to put stuff. its fairly simple. LABELING ALL WIRES ARE YOUR FRIEND! Dont just hack a whole harness at once. if you dont have alot of experience, cut one wire at a time because honda tends to run more than one of the same color in a single loom.

[projectaccord]

http://www.azht.net/forum/showthread.php?t=44389

there ya go bro. it helped me alot lol.

http://www.team-integra.net/forum/display_topic_threads.asp?ForumID=16&TopicID=190317&ReturnPage=&PagePosition=0&ThreadPage=1

this one will help a little too

[IntegraDA]

^^whatever you do...make sure you always use split-loom tubing and electrical tape to make sure your wires are protected from vibrations and the elements like water and dirt. i would highly advise soldering and heat shrinking EVERY joint in the wire, just to make sure you have a proper connection and so you have a peace of mind that they wont come undone.