Hub question

[Rxseven2civic]

is the bearing race size the same from a usdm itr and a gsr?

meaning could i pull the five lug hub off and have it pressed into a gsr spindle?

[*inFamous*]

When i looked it up, the outter Diameters are so yes, you can as far as i remember. I was looking at converting mine over using all new OEM hubs/bearings and i pulled a few out to measure and believe it came out ok.

I'd hunt around on honda-tech but im pretty sure you can.

[Rxseven2civic]

i have a bad ball joint, i just thought it would be easier to press the five lug into my old spindle

[teamsol]

mmmm if im not mistake, even if you press a hub into your spindle you are not going to be replacing the ball joint.

[Rxseven2civic]

mmmm if im not mistake, even if you press a hub into your spindle you are not going to be replacing the ball joint.

you are mistaken

[KingDingaLing]

you are mistaken

ball joint is easy dude

[Rxseven2civic]

took the spindles over to badchkn's house and he hammered the hub out, put it in the gsr spindle, put a new bearing in and hammered it back in. turned out the spindle was bent from the wrecked itr i got the itr spindle off of.

badchkn :thumbup: all for a jamba juice