PDA

View Full Version : Diy


MrRline2010
02-23-2008, 09:44 PM
I'm looking for a DIY instruction guide for removing the face around the head unit. Need to run my remote and amp cables tommarrow, but not sure how everything comes apart. Anyone know of one out there?

Rufus
02-23-2008, 10:08 PM
Remove center console, two bolts underneath, remove vents (they pry out on the side), pull dash out (it's held in place with clips).

MrRline2010
02-24-2008, 12:11 AM
eh I was just seeing if anybody had any detailed drawings somewhat knew the process already thanks though. I can't wait to get everything ran and hooked up. Hey rufus how many watts is your amp pulling for your setup? Do you know what speaker sizes your running

Rufus
02-24-2008, 08:17 AM
I run a 500/1 and a 300/2. The kicks are 6.5's as well as the rear deck.

MrRline2010
02-24-2008, 11:19 AM
is your setup bridged? My buddy said he was loosing too much power when he bridged his setup.

Rufus
02-24-2008, 12:54 PM
lolz

Bridging cuts impedance in half, thereby effectively doubling ouput.

Your friend eats crayons.

LatinEM1
02-24-2008, 03:55 PM
Audio Unit Removal/Installation

NOTE:


Put on gloves to protect your hands.
Take care not to scratch the dashboard and related parts.
Make sure you have the anti-theft code for the radio, then write down the frequencies for the radio's preset buttons.
Remove the dashboard center lower cover.

http://library.alldatapro.com/alldata/LIB~C38989~R0~OB0~P3R0H~N/0/101825161/104211100/105706790/105706792/34853741/34866247/34866341/34866447/131956313/104034124/104065184





Remove the two mounting bolts, then pull out the center panel (A).
Disconnect the audio connector (B), antenna lead (C) and the A/C connectors (D), then remove the center panel.
Remove the heater control panel.

http://library.alldatapro.com/alldata/LIB~C38989~R0~OB0~P3R0H~N/0/101825161/104211100/105706790/105706792/34853741/34866247/34866341/34866447/131956313/104034124/104072914





Remove the four mounting bolts and the audio unit from the radio brackets.
Install the audio unit in the reverse order of removal, and note these items:
Make sure the audio unit and A/C connectors are plugged in properly, and the antenna lead is connected properly.
Enter the anti-theft code for the radio, then enter the customer's radio station presets

MrRline2010
02-24-2008, 08:20 PM
mine didn't have any of that. I went from the center console and removed the panel around the shifter section then from there I was able to take a screw driver around the outer edge of the air conditioner/stereo console and pops right out. Everything is hooked up now sounds great.

HondaTech1607
04-28-2008, 07:26 AM
If you have any type of Honda or Acura that needs some Maint., Or other type of work done send me an Email to J_monsisvais@hotmail.com. My labor prices are alot cheaper than indepentdents, and of course dealerships.

sniperscout
04-28-2008, 08:56 AM
mine isnt screwed in so i can just pull it out at any time.

i like the orange crayons myself