no i dont but when you go into honda tell them that
you have a eg hatch cx i believe and you need the rear window plug...
those cars had a factory plugged if i remember and they fit in teggys

Lol just have them pull up the firewall diagram, theres only one big plug below the battery tray :) If they cant do that for u, they shouldn't be working parts.

do you have the part number for ace??


I cant pull up the part number but check these thread on ht they have them on there

for the rear window delete plug

:wave1:

oh yeah and Ravi(?), IntegraLS is SUPER smart about tegys!! :clap:

when i grow up i wana be like ravi:snookems:

thank you i will do this 1st thing tomorrow:clap:

x2 .

sound simple enuff, think im gonna do the same.......

dropped 20 bucks at honda for the cx window plug..i didnt have the plug under the battery tray and homie depot didnt have nothing similar

Personally i turn the defroster on, and concentrate on whats in front of me more than whats behind me :)

u just hav all the asnwers

no, just LOTS of answers lol, but many questions as well. Like how many meters does the earth curve in a 4km span

hmmmm good one

errrr this many!

Every 2 miles the earths crust drops 2.7ft, or for every 23 miles it drops 9.8meters... which happens to be the rate of the acceleration of gravity, so if you can move approximately 23miles/second you will be in orbit! Thats fast! Of course thats a ground level orbit which is much faster than say a 185mile high orbit :) Speed there is closer to 5miles/second or 17,000mph :)

I think snipers use that

this is the part number at honda 90301-SR3-000 23 bucks

Will this fit a 97 teg?

yes sir..but thats just the plug you are going to need the other 3 pieces behind it

??? what other pieces you need? you should need just the plug and that's it, if anyone need one lmk i have # oem plugs left

What other pieces do i need? Do you have the part numbers if there is any?

How much?

Is this for the metal or rubber plug? I used the metal plug but its been so long i dont have the part number or receipt or anything relevant. Sorry... But if you can I'd suggest the OEM Metal plug. It just required the plug, a screw,a grommet and a big washer. Dont mind how dirty my car is :)

Sweet, i found the how to that I used with all the OEM part numbers for the metal plug...



BTW - ICD has the correct part number :thumbup:

Yeah and it's metal 20 bucks at honda I'll try to get the part numbers that holds the plug in the back

Clink the link in my previous post, all the part numbers you need are there :thumbup:

Damn good info... Thanks.

NP.. the only thing extra I did was trim the grommet down with an exacto knife so it would mount flush with the window.

:clap:

So this is where my old hatch went!

wtf are you talking about and good job bumping old threads you guys..