I'm going to prep them and paint them silver with krylon spray cans, that should be close Enough to stock I hope

Today I also installed a gsr axleback, no more noisy straight pipe!

wheels look great frank! i like em alot better. ive just been cutting and buffing my car so i can put the finishing touches on it :)

Replaced the a/c in my sedan, now to replaced a terrible leaky radiator.

Gave it a bath and waxed the shnikey's out of it! Replacing brake pads soon; they are starting ti squeal at me.

Installed some spark plug wires

Isee post pics when installed bro also how much did you pick em up for

Just a heads up, If anyone is interested, I found a pair of password jdm fogs for eg's at freds u-pull it, he was only charging 25$ for them, but they were missing the silver cover for them.

but not a bad price at all

where is it located

i saw you at the qt on vanburen by tolleson on saturday car looks good man

North Phoenix, like 23rd avenue and deer valley I believe

bye bye guys sold my ej1 yesterday and got back in a ed3

Today I'm going to spray the last one and throw em on the car. I honestly paid too much man, I drove out to north phx for them and the d00d wouldn't go down on price. 35 bones.

Im going to be switching out rails from these DC seats since they are bent, I'm sure my eg rails will fit though.

Hopefully figuring out why Breezy's EG wont run.

Fitting new front bumper :)

Put gas in it

new clutch master and flushed old fluid.

wiating for pay day for the new rims

FAILED EMMISIONS!!!!!:lightsword::dumbass: and got valve adjustment done and properly set timing!!! hopefully I can pass emissions now!:biggrin:

^ nice job, better safe then sorry!

Yeah it turned out pretty good

Learning how to swap a motor in Breezys EG, since its completely fucked.

Took p.s belt off, had a leak and dont really care for p.s anywho so ill deal with it later.

Quick 2-5hp!! lol :drive:

Also filled her tank up a bit!

Throw on some stainless button head allens instead of the zipties. Use blue loctite though so you don't have to tighten them enough to indent the plexiglass. Also looks like you forgot to remove the film?

The film is off.. And i put zip ties cause when i pulled the ecu and looked at it the threads where stripped out and there was no cover on it. Sooner or later ill rethread the holes and put screws in but its something that is never seen so the zipties work for now.

Thanks man ya I work out that way.

Where'd you buy the plexi?

Home Depot