axle question
Is there a difference between b series axles. . for civics and integras..?? I always thought they were the same.
Let me explain why I ask... I had purchased a passenger side axle awhile back, said it was b series, had a ls trans, and never had a problem. .. I put a b16 trans in my car and I got a slight shake/wobble when I shift into 2nd and 3rd... I believe it's a "integra" axle because I got a new tranny seal and asked for a 2000 si but it wouldn't sit tight on my axle... so I took it back and brought my axle and tried a few different ones and the integra axle seal fit perfect... so what I'm asking is, is there any difference in lengths on the axles.. Also I noticed when I try to put my axle in, it only let's it go in so far (it goes in as far as it will let it), and sits kinda loose, when I had the ls trans it wouldn't move like that and appeared to go in a little further.. Could it be my axle or my differential in my b16 trans?.. I got no grinds or pop outs but something don't seem right.. any help?? |
Anyone?
|
i could tell you but then that wouldnt be any fun now would it :guns:
|
Hahahaha... it's a serious question buddy
|
are these autozone axles that you have?
all 94-01 b-series axles are the same. integra, del sol, civic si |
I'm not sure.. I got it from a guy on Craigslist awhile back.. it was brand new in the plastic but no name was on it..
|
What could cause my problem? Could my differential be fucked up?
|
more than likely shitty craftsmanship on the axle
|
typical autozone, checker, pep boys axle from the sound of it
|
I will replace it and see what happens
|
But if you say integra and civics have the same axle.. why did the si trans seal not fit the axle itself , i had to get a integra axle seal
|
I've had problems with autozone axles not even being close to fitting. |
But it didn't do that with my ls trans that's what I don't understand
|
That's the kicker
|
That is weird. I mix and match axles all the time. B16, small spline ls, big spline b16, never had a problem.
|
I can't figure it out..
|
Same shit.. still got a 1/8 to a 1/4 inch gap.. could the spline be too long? I went to vato zone and got another axle and it's doing the same shit
|
All times are GMT -7. The time now is 07:26 AM. |
Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
ŠAZHT.net 2004-2021