Will my cage pass tech?
|
1.) Welcome back
2.) Long time no see 3.) You got a cage??? Bout time! :thumbup: 4.) What organization are you asking about for tech? |
Thanks Gabe, I'm just curious to see if it would pass tech with the NASA AZ guys. What are your of thoughts of it? Like is it safe or functional?
|
|
Without being able to see the weld penetration and check to make sure that the tubes are welded a full 360 degrees around the circumference of the joint it's kind of tough to comment on the safety aspect.
I'm sure it's stiffened up the chassis quite a bit, so from that standpoint it's functional. :thumbup: |
joweeee
glad to see you are still around! |
How about the diameter of the diagonal bar? it's one inch in diameter. As far as complete welds, there are over 8 areas that aren't completely welded... So I guess that's a fail... Thanks for the info! I Have a few more pics I'll post later tonight.
|
Fix it again tony :wave1:
|
That's no bueno man. I know it's not what you probably want to hear, but could you cut it out and sell it to someone who may be looking for something for more of a show car build and take the money and put towards a roll bar or roll cage with property diameter tube and better quality welds? Would be much safer in the event of an accident.
|
All times are GMT -7. The time now is 05:49 PM. |
Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
ŠAZHT.net 2004-2021