1989 ef hatch with a b20 (junk) swapping in a b16
 

ok so im done with b20's for ever so i got a b16 from hmotors online and i have never swapped a honda before im a certified motorcycle tech so im cabable of doing the swap its currently a b20 with multi point conversion, runs fine im just done with pos b20's. so the mounts and shift linkage i have will work for the b16 and the axles will work. my only question is in the wiring i have the boomslang obd0 to obd1 harness from kingmotorsports ive tried looking up wiring diagrams but to be honest im not very good with wiring any help or suggestions would be great i can bolt up and hook up the wiring just fine its just wiring it for vtech that im concerned about thanks for reading guys and thank god for azht if i figure this out it will save me 800$ ****B20 ISNT JUNK RUNS LIKE A CHAMP IM JUST NOT LOVIN THE WHOLE THIN CYLINDER WALLS

and



these helped me out with wiring

gl with the swap

the wiring between the b16 and b20 wouldn't be really different at all, it's going to be adding some wires for vtec, that should really be it... most of the sensors should be close to the same places so maybe extending a few.

if you need someone to help you man i can help with the swap and wire it up for you man! im goin to tuscon to wire a friends hatch on sunday let me know!

ya
 

hell ya lemme know 520-275-8246 once thats done ill be golden

what are you gonna do with the b20 bottom end?

if u need a b20 i have 3 f/s.