Valve Cover Cutting
Anyone in town do plasma cutting? I want to get the timing belt area chopped off. Any recomendations? Thanks
|
use a dremel
oh and dont cut the timing belt.. |
Ummmm the valve cover is off the motor. And a dremel is nice and all but id rather have a pro do it!
|
f
pro only, mine was chopped but done in japan
|
i would use a band saw or a cut off wheel. It will clog the disk up but it should be good enough for that size of cut.
|
Chris hit me up my neighbor does it....
|
just use a grinder. thats how I did mine
|
a grinder or cut off wheel will do a much cleaner job then a plasma cutter. you can do this yourself with as good of results as any "professional".
|
i would think a grinder would work fine if you take your time and just clean up any uneven parts after
|
just use a dremel or a grinder with a cut-off wheel, la a tape line where you want it to be cut, and go slow and steady
Plasma cutter would be the wrong choice for cutting that. |
Fuck cut the timing side off completely like I did...
|
plasma cutter does a better cutting job than a grinder by far!
|
1 Attachment(s)
i use a mill and just take enough material off to remove the end of the cover. a plasma cutter is a HORRIBLE way to do it. a grinder with a .040 thick cut off wheel will also do just be careful when using that thin of a cutoff wheel, if you lean on it sideways too much the cut off wheel will explode and you will most likely cut a few of your fingers. below is a b series i did. good luck
|
I would not use plasma or dremmel
|
just be careful and don t do it all boondock status lol
|
its aluminum it will probably worp with a plasma cutter
|
All times are GMT -7. The time now is 04:21 PM. |
Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
ŠAZHT.net 2004-2021