Fucked up header!!.
|
Well you could always cut the rest of the stud off. Then drill it out the part that's still in the flange and use a nut and bolt afterwards. Just a suggestion.
|
grab the studs with vise grips, turn them out, find new studs.
|
i may try that thanks.
haha ya tried that and it didnt work. |
drill a hole through the stud, or grind a slot in it, then insert a nail/screw/screwdriver and try to torque them out
|
i have nothing to drill the hole with.
|
a good set of vise grips and and some heat should take them out. got a torch?
|
A small pipe wrench will also dig in tight if you wanna loosen bolt. Use some penetrating lube first. Or use suggestions above and drill it out. A cheap black and decker corded drill is no more than $15.
|
All times are GMT -7. The time now is 04:43 AM. |
Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
ŠAZHT.net 2004-2021