TSR Battery relocation trays
|
RCG APPROVED!!! I run one on the mugen eg9 4dr. Love it!!
|
Would you sell jus the battery hold down kit? If so how much
|
Sorry battery hold down is not available separately.
|
:thumbup:
|
Damn that thing is fresh!!!
|
Bad Ass!
|
That thing sure is pretty, and makes this job a LOT easier than it used to.. Whoever came up with the plan to make those deserves to get rich! :)
|
This pass spec at tracks? I doubt it.
:drive: |
Sooo this doesn't fit 88-91 civics?
|
Yes it will pass tech. Since the battery is in the front of the car a sealed box isn't necessary.
Sorry it will not fit 88-91 Civics. |
Oh so sexy.. may need one soon.
|
If they were $100 cheaper I would've bought one already. :o
|
Have you checked with NASA AZ etc regarding of its tech legality for RR?
|
Nice work Aaron, you should sell some battery tie downs seperate, I would buy one.
|
This will pass NASA hpde and race group tech. The mounting hardware is equivalent (if not better) than OEM. The rules do not prohibit relocation position of any sort. They only require the battery to remain secured in its position without moving in the event of a spin or rollover AND have a non conductive cover over the positive terminal. [NASA CCRs, section 18.8, page 78]
Not applicable to this kit, but the CCRs go on to say that gel cells need to have a sealed marine type case if mounted inside the driver's compartment. |
this thing is badass! Super simple!
|
All times are GMT -7. The time now is 10:19 AM. |
Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
ŠAZHT.net 2004-2021