2 Pioneer 12s
 

I have two pioneer tsw3002d2 subs in a dual ported box
I have an alpine deck 2 batteries 2 sets of 4 gauge power wire
Also 2 for the ground 4 gauge
and 2 Blackmore 3200x1 amps (i know not the best but gets the job done)
there a 2 80 amp fuses in the truck one for each amp and for some reason when i
turn it up after a couple days of listening to it a fuse pops what would cause this??
:wave1:

What resistance are the subs wired for? 1 or 4ohm?
Gain is set at?
Can you turn it up high enough anytime and blow the fuse?(only 1 or both blow?)

Grounds all connected good? None of the power wires are grounding out anywhere?

uummmmm......... what he said.... ^^^

power feed wires too small. 3200? thats a big amp. You would need 0 guage feeding it

Same thing goes for the ground. If you have dick ass ground then there is also more resistance on power line I believe