Skunk2 intake manifold
 

Question I have a 02 rsx base and I was thinking about getting the skunk2 pro series intake manifold. I wasn't sure if it would require any tuning or if I could just bolt on and play. I currently have a aem cai comptech long tube header also a header back obx-R exhaust and didn't know what will be the next move to go. I'm currently installing a exeddy stage one clutch and 8.9lb flywheel also exeddy.

Do you have kpro installed?

It's required before you can remove your stock intake manifold due to the intake runners that need to be disabled in the ECU

Ahh I see and no I don't I figured that it would need that. I just wasn't sure where's the best place to get one with out being screwed.

Locash Racing

And you'll probably want a basic tune to maximize the effectiveness of your boltons