Offset and Rim Gurus...
I have a 47 offset on my rims for my car. I wanted to get some 25mm spacers to flush it out some.
I found a set I want here: Problem is, there are no centercaps available for my line of wheels, so am I gonna have an ugly hole in the center of my wheel with the spacer installed? |
Does anyone have a collection of centercaps or know of a shop that would be willing to help me?
|
measure the diameter of the hole. there maybe a center that will fit. post what size it is and i could tell u what center cap will fit.
|
well the problem is the dustcap on my rear wheels protrudes some so a flat cap would not fit
|
What rims do you have?
|
|
can you post pics from like the side? if you put 25s in the rear you would need to stretch a lil or get moAr camber lol
|
I've always loved these rims, too bad they never made a center cap.
I wouldn't worry about a center cap, even If you put in a generic "honda" center cap in it, i think it would look ugly. The rims look good without it. As for a "big" hole in the center, it shouldn't look to bad. |
I plan on rolling the fenders and raising my ride height
I just am looking for an example of how it would look with that extra inch |
:facepalm:
nooo you are supposed to go lower |
Yeah man, Keep it low.
I wouldn't worry about the "big hole." |
I am getting kinda tired of bottoming out on speedbumps.
If I keep it lower I will have to have the front fenders rolled as well which means I have to tear out the black fenderwell lining and that is a little trashy in my opinion. |
talk to Smoot. i know he did something different for the center caps on his Volks because they dont make caps for those wheels. i think he just found the approprient sized plug and had it paint-matched.... or idk, something like that
|
Yo if your looking for spacers I have a few sets Ill sell you all of them cheap can meet you pm me if interested
|
I am getting a brand new set for 160 shipped with new studs already pressed
|
|
|
So i ordered them, now I gotta get the damn fenders rolled lol
|
No, I actually have Volk center caps. When ordering any kind of Rays wheels, you have to order them extra., and since I didnt, I had to wait a couple more months for them to get here.
The wheels don't come with center caps because of they are racing wheels and most/all tracks do not allow centercaps on wheels, due to the fact they can fly off and cause saftey issues on the track. Now if you take them to a wheel place, they can possibly design/cnc a center cap for you. I know DVP GSR had them done for his Volks |
you mind asking him for me? |
He had Nu Wheel do them.
|
ok well where are they located & stuff
|
What are your plans with the fender rolling and what not?
|
Not sure
i know i need to roll my rears, prolly gonna have tri-tech do them i may raise my ride height a bit too I don't wanna have to roll my front fenders if possible. |
lmao... say good bye to ur wheel bearing soon lmao !!
|
Why would you even say that....especially since he's only flushing the wheels out. IMO, that's just an asshole comment. |
Are you going to get hubcentric rings for your spacers? You dont want the load to be on the studs. I see guys sport without them and do fine, but just thought I throw that out there for peace of mind to consider. It would also eliminate wheel vibration if any occurs after the install
|
All times are GMT -7. The time now is 04:55 PM. |
Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
ŠAZHT.net 2004-2021