Chrissy's 11.6 pass all motor... easy launch
She launched soft, but still a good run for a single cam!
|
wish i could soft launch a 1.6 60'.
|
Fuking sik!!! In about a month tell her I'm going to be in her lil club:)
What are her specs again? |
It is a good club to be in. :)
Here is the link to her build... |
What size slicks? What suspension setup
|
Very nice!
|
24.5" Mickey Thompson slicks and Tein HA coilovers up front with custom Progress Technologies rear coil overs.
|
thats just so fuckin amazing how shes getting a 1.6
what lsd and traction bar is she running and where is she launching/preloaded at? |
She typically pulls upper 1.5x 60ft times. That launch was basically off idle. She was worried about the car creeping forward. I need to add a line lock for her. The trans is very exotic... It is my faceplated euro r trans with a 4.64 fd and a custom ultralight quaiffe LSD. She isn't running a traction bar. Normally, when she isnt dealling with the creeping issue, she launches at almost 7500 rpm. Little or no preload.
I intend to change her to a b16 trans, like I am running now. I should see her drop into the 1.4x times after that. |
Amazing!! I'm super stoked and excited to see what my DA will run :)
|
my GOD!!! |
All times are GMT -7. The time now is 03:14 PM. |
Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
ŠAZHT.net 2004-2021