Alright heres the deal
 

Wired my 90 civic dx with obd1 clips and it wont start. The only wire that I dont have hooked up is the blue and white wire on the A clip (the clucth interlock switch) and I was woundering where it goes on a 90 civic dx?

Also my hazard fuse keeps on blowing I was woundering might cause this? Give me a list of shi% that could make it happen.

Is it getting spark or fuel? Did you just change the injector clips to OBD1, or do a whole OBD1 conversion?

I did the whole obd1 conversion. Hasport made the engine harness and I put on the ecu clips on I think I might of had a couple of wires wrong.