AZHT.net

AZHT.net (http://www.azht.net/forum/index.php)
-   All Motor (http://www.azht.net/forum/forumdisplay.php?f=91)
-   -   Cylinder Head Information (http://www.azht.net/forum/showthread.php?t=79727)

lramon_1 10-23-2008 02:08 PM

Cylinder Head Information
 

honduh_head 12-23-2008 02:18 AM

GSR vs PR3 (b16/type r) head comparison


CiviCChiC21 02-03-2010 03:55 PM

new to this site and that was good info... i might be in the right place to learn more online!

honduh_head 02-06-2010 12:18 PM

thanks for dropping by... please make a thread in the welcome section and say hi to everyone :bananalama:

Dead Bird 02-06-2010 12:37 PM

I like this better:



but more importantly:



Notice though:

I dunno how you guys feel about it, but I would like to think it's true. Kinda a good example I believe:



And if I remember correctly, the "sparks" pistons he's using are almost the same as the RS Itr's. They ARE cast, but seem to be free floating. Rated at 11.8:1 compression, just like the Itr's with a GSR head, so I'm not sure why he says they're 12.1:1. Looks to me like the made a cast of wiseco skirts and the itr domes.

Found here:


lramon_1 02-06-2010 04:13 PM

thats a good deal

honduh_head 02-08-2010 06:28 PM

those sparks look dope for that price

Dead Bird 02-08-2010 07:00 PM

same as RS's ITRs, are they not?

RS: 300 shipped on ebay
Sparks: 289 shipped or non?

But they are free floating right? So they can be used with Aftermarket rods. :)
RS says theirs can, but not sure off the shelf

honduh_head 02-08-2010 10:25 PM

i didn't dig that deep into it, but they're def something i'm going to look into in the near future.


All times are GMT -7. The time now is 09:51 AM.

Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
ŠAZHT.net 2004-2021