96 handa civic front bearings
i have a 96 honda civic ek that have bad bearings, they sound like if i have mud terrain tires!!!!! i just wanted to know, is it hard to change them????? never changed a bearing before!!!!:smackself: i know, i know, i aint the brightest man in the world i'm just "seventeen":biggrin:
|
Man? Ur a teen still hahahaha
|
They need to be pressed out of the hub most mechanics can take care of it.
|
hell yeah im young!!!!!
|
You can get new ones pretty cheap my friend. I suggest changing both front/both back at the same time. Just pull the hub off, take it to a mechanic with the new bearings. Have them press the old ones out and place the new ones in. Place hubs on the car, Eat icecream for success :)
|
And when i meant both front/back at the same time. I meant pairs. If your front one is bad. Change both front bearings. vise versa if they're bad in the rear :P
|
hahahaha yeah thats wat i was ganna do that change the two front ones now n wait like 2 weeks wen i get a little bit more money then but the rear ones next...
|
Its not hard dude ill do it for you..haha
|
Make sure this is a wheel bearing and not a bad axle. They will make similar noises. If the hub has axial movement then I would go after wheel bearings
|
bad bearing may not always have movement.. unless they are completly gone, jack up your car, put it in neutral, spin the wheel with one hand the other one on the coil youll feel the bearing ''grinding''. also on the road test, you can swerve left to right, turn left the noise gets louder means right side is bad vise versa.
|
Put your car up in the air and grab a hold of the tire and try to move it side to side like you are trying to shake it...if it moves then you most likely have a bad hub bearing.
|
what if you have a bad tie-rod?^^^
|
well ill check till i get it back from the inpound lot!!!!!!!! :p
|
Inpound lott?
|
they are hard to do unless you have a press. or you could end up damaging them on install. that is why you should buy the ones im selling.
|
i heard u can get them press at pep boys but im not sure!!!!!!
|
yes $35 for each bearing
|
shit ill do it for 20! bring me your stuff!!
|
All times are GMT -7. The time now is 06:33 AM. |
Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
ŠAZHT.net 2004-2021