AZHT.net

AZHT.net (http://www.azht.net/forum/index.php)
-   Welding and Fabrication (http://www.azht.net/forum/forumdisplay.php?f=161)
-   -   Swirl pots (http://www.azht.net/forum/showthread.php?t=185500)

Bill Cosby 01-24-2013 06:24 PM

Swirl pots
 
Was wondering if anyone has used them for their road race cars. I see setups for fuel swirl pots and i saw a coolant one on k20 built by pacman. But it didnt seem to make sense to me. Can I just run the swirl pot inline between the head and upper rad hose?

honduh_head 01-25-2013 04:24 PM

I believe you want it on the out let line, not the inlet. we had one on the shop s2000 but its been so long since i looked it at i'm not 100% what was done (was built way before i got there)

Koopa Troopa 01-25-2013 07:48 PM


Bill Cosby 01-26-2013 07:19 AM

Ok I saw that now tell me how to route a hose directly to the combustion chamber

Koopa Troopa 01-26-2013 11:45 AM

That hose should come right off the bleeder screw.

Bill Cosby 01-26-2013 04:36 PM

Not sure k series have them.... Still it makes no sense. Stand by ill get on my laptop and post pics

Koopa Troopa 01-26-2013 04:50 PM

Then T a hose into the highest part of the coolant system. That's what the "combustion chamber hose" is representing

Bill Cosby 01-26-2013 05:41 PM


Bill Cosby 01-26-2013 05:49 PM


Koopa Troopa 01-26-2013 06:02 PM

I don't think those are doing anything other than filling with coolant...

The point of the swirl pot is for trapped air to be able to escape.

Bill Cosby 01-27-2013 11:57 AM

aww shit i didnt even realize that the radiator in the crx was turned sideways


All times are GMT -7. The time now is 09:49 AM.

Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
ŠAZHT.net 2004-2021