-   Engine Building (
-   -   D16z6 valve tick. (

HondaFisher 06-26-2014 09:41 PM

D16z6 valve tick.
I've been building a z6 for a while. Went a few routes, or should say I had a few dreams, but it's just a stock NA build with 75.5mm pistons.

Right now my only issue I've run into is a nasty valve tick, seems to be exhaust side of cylinders 1,2, and 4. Cylinder 3 seems to be quiet.

I've adjusted the valve lash multiple times and I believe I have done it to spec...
1-3-4-2 turning the crank counterclockwise so the rotor turns clockwise.
This is correct right?

I believe the first time I did it, I turned the crank clockwise.

Other than that the engine runs smooth, no oil burning or anything like that.

Does anyone have some input on what it could be?

HondaFisher 06-27-2014 12:36 PM

Here's a link to a video

HondaFisher 06-27-2014 12:47 PM

I've done the valve lash to specs. Still not getting anywhere.

All times are GMT -7. The time now is 02:32 AM.

Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.
Š 2004-2018