Brake issues
 

So I bought a 89 sedan and everything is fine but the brakes. When I press on there's no pressure and it doesn't stop at all. Where should I start with this? There's brake fluid in there.

If you dont see any busted or unbolted lines, then new/used master cylinder.

check for fluid leaks, check for broken lines / disconnected lines, check to see if air is escaping the booster, check to see if the master is leaking, fill the master and check the floor by your pedals to see if it's leaking through the firewall. i'd check them mostly in that order.

i would check the front calipers. ive had 4 blow out in the past few months and after replacing and checking the usual suspects as others have mentioned i finally noticed fluid in the rim and such :icon_eek:

So I found a cut line in the drivers side, replaced it but I'm not sure I bleed them right. Any proper information on how to online somewhere? I did the passenger then the driver... Still no stiffness.

Here's a stiffy :031:

:rflmao:

Maybe need to bleed all four and/or bleed the master.

man i don't remember the last time i bled only two brakes on a car

I did my rears which is obviously the first 2 to bleed then a week later I did my fronts. I suggest rebleeding all of them

All or nothing for brake bleeding since the reservoir does not separate front and rear.