View Single Post
Old 11-03-2009, 08:25 AM   #54
BDD
 
Join Date: Dec 2006
Location: tucson
Posts: 15
iTrader: (5)
Quote:
Originally Posted by gunsup0331 View Post
anyone think ill hit the pistons?
85mm b20 with RS machines pistons on GSR crank/rods
.006 off the deck
.5mm over supertech valves
Supertech springs and retainers
Skunk2 pro 2 camz
compression should be right at 12:1
3layer HG
The problem with this setup is that you wont be able to run correct cam timing because your .5mm oversized valves will touch or be to close at the degreed spec for the pro 2's, and you'll have a shitty power band. So oversized valves will more then likely hurt your setup.
__________________
94 civic cx, 84x89 benson sleeved GSR block, Portflow GSR head, skunk2 tuner2 cams, 6262, Neptune, 724@28psi
BDD is offline   Reply With Quote