AZHT.net  

Go Back   AZHT.net > Model Specific Tech Forums > EF CRX/Civic + DA Integra

EF CRX/Civic + DA Integra CRX/Civic (88-91) and Integra (90-93) Discussion

Reply
 
Thread Tools Display Modes
Old 09-22-2009, 11:54 PM   #1
94gay-lude
<3 larelle
 
94gay-lude's Avatar
 
Join Date: Jan 2007
Location: mesa
Posts: 6,385
iTrader: (32)
si trans swap...

so i put an si trans in my ef, new clutch too. my friend at work (very respectable honda tech) rebult it (sorda) for me. he replaced the diff bearings, main shaft bearing, 1/2 gear hub and shift forks. but for some reason it doesnt like to go into third and fourth since the swap. no grinds, ill push to where it should just "fall into" third, and it just wont go, i have to jiggle it back and forth a bit before it will go. anyone know why?


and yes pat, its your old trans...lol
__________________
Quote:
Originally Posted by THE Slow 5.oh? View Post
there was so much diversity. Now its like EVERYONE and theyr whore mother follows the same internet based new fads

Quote:
Originally Posted by Majik1r View Post
Daaaaaaaaaamn!!! Maybe you'll have these when I'm not a broke failure. lol
94gay-lude is offline   Reply With Quote
Old 09-23-2009, 12:00 AM   #2
94gay-lude
<3 larelle
 
94gay-lude's Avatar
 
Join Date: Jan 2007
Location: mesa
Posts: 6,385
iTrader: (32)
p.s.- can a 90 crx si engine harness be used in an 89 crx si?
__________________
Quote:
Originally Posted by THE Slow 5.oh? View Post
there was so much diversity. Now its like EVERYONE and theyr whore mother follows the same internet based new fads

Quote:
Originally Posted by Majik1r View Post
Daaaaaaaaaamn!!! Maybe you'll have these when I'm not a broke failure. lol
94gay-lude is offline   Reply With Quote
Old 09-23-2009, 06:39 AM   #3
die in a dick fire noob
Formerly a SWKPH
 
die in a dick fire noob's Avatar
 
Join Date: Feb 2007
Location: Pee ho nix
Posts: 11,314
iTrader: (51)
i think the 89 plugs are different... and dude this transmission is cursed for you... remember when we drove in it and it shifted fine into everything then you take it apart and shit is in like pieces...

if it won't go into gear something wasn't put back right, i know you have to take them apart a certain way and put them back together in order, but other than that i really couldn't tell you, you could talk to tage but i'm sure he's busy, other than that maybe ask simon (iliketodrive) since he's the second tranny person i know.
__________________
die in a dick fire noob is offline   Reply With Quote
Old 09-23-2009, 09:33 AM   #4
94gay-lude
<3 larelle
 
94gay-lude's Avatar
 
Join Date: Jan 2007
Location: mesa
Posts: 6,385
iTrader: (32)
lol, i remember, but i was hoping maybe it had to do with, idk my shift linkage or something, lol
__________________
Quote:
Originally Posted by THE Slow 5.oh? View Post
there was so much diversity. Now its like EVERYONE and theyr whore mother follows the same internet based new fads

Quote:
Originally Posted by Majik1r View Post
Daaaaaaaaaamn!!! Maybe you'll have these when I'm not a broke failure. lol
94gay-lude is offline   Reply With Quote
Old 09-23-2009, 09:56 AM   #5
die in a dick fire noob
Formerly a SWKPH
 
die in a dick fire noob's Avatar
 
Join Date: Feb 2007
Location: Pee ho nix
Posts: 11,314
iTrader: (51)
nah i'm gonna say it has to do with how it was put back together, when the car is off does it go into every gear? if so it could be a clutch issue...
__________________
die in a dick fire noob is offline   Reply With Quote
Old 09-23-2009, 08:26 PM   #6
holla@me
AZHT's resident DRUNK
 
Join Date: May 2007
Location: NOT BANNED
Posts: 1,786
iTrader: (10)
3-4 shifter fork. EFs are notorious for bending their aluminum shift forks. the way its worded in your original post, i can't tell if you replaced all three shift forks or just the 1-2?

what kind of condition are your engine and trans mounts in? makes more of a difference than you'd think.

you WILL find your answer in the D-series.org forum for trannys (lol). just skim the threads until you see responses from transzex and aquafina. especially transzex, aka Mista Bone, he is THE tranny god. period. he's from the Hybrid.jp days...

http://www.d-series.org/forums/transmission-alley/

my posts containing opinions about TAGE always seem to mysteriously disappear, so i'm going to leave alone the earlier suggestion to contact him....
holla@me is offline   Reply With Quote
Old 09-23-2009, 08:32 PM   #7
94gay-lude
<3 larelle
 
94gay-lude's Avatar
 
Join Date: Jan 2007
Location: mesa
Posts: 6,385
iTrader: (32)
hmm, i dont remember we rebuilt it a long time ago, pat did you give me both shift forks or just the one?

oh, and my frint and rear mounts are brokem, lol. but it had no shufting troubles with my dx trans. UNLESS, maybe when i put the passenger mount on i put it on slightly cocked? cause it has the slotted holes so you can move it. oh and also, you know how you would move it to the left to go to first and second? but its still in the nuetral position. well it doesnt "snap back" like it does over to the right by 5th and R. acytually, it doesnt snap back really at all. just kinda sits there, limp....
__________________
Quote:
Originally Posted by THE Slow 5.oh? View Post
there was so much diversity. Now its like EVERYONE and theyr whore mother follows the same internet based new fads

Quote:
Originally Posted by Majik1r View Post
Daaaaaaaaaamn!!! Maybe you'll have these when I'm not a broke failure. lol
94gay-lude is offline   Reply With Quote
Old 09-23-2009, 08:38 PM   #8
holla@me
AZHT's resident DRUNK
 
Join Date: May 2007
Location: NOT BANNED
Posts: 1,786
iTrader: (10)
your DX trans might have adapted, or over time, YOU adapted and didn't notice the possible issues with your mounts.

seriously...REPLACE those and go from there. they can't be too pricey with your discount?

i'm a strong advocate for stock mounts and stock shifters. i've had troubles in the past, and all is solved with a good set of mounts and the stock shifter. geometry is everything when tolerances are designed to work only within close specs...

btw PM'd
holla@me is offline   Reply With Quote
Old 09-23-2009, 08:40 PM   #9
94gay-lude
<3 larelle
 
94gay-lude's Avatar
 
Join Date: Jan 2007
Location: mesa
Posts: 6,385
iTrader: (32)
who, you pm'd me?
and i will do that, like asap, cause this whole "taking 10 seconds to find third gear" thing is going to get me rear ended...lol
__________________
Quote:
Originally Posted by THE Slow 5.oh? View Post
there was so much diversity. Now its like EVERYONE and theyr whore mother follows the same internet based new fads

Quote:
Originally Posted by Majik1r View Post
Daaaaaaaaaamn!!! Maybe you'll have these when I'm not a broke failure. lol
94gay-lude is offline   Reply With Quote
Old 09-24-2009, 05:08 AM   #10
die in a dick fire noob
Formerly a SWKPH
 
die in a dick fire noob's Avatar
 
Join Date: Feb 2007
Location: Pee ho nix
Posts: 11,314
iTrader: (51)
oh i didn't know your mounts were destroyed, change the rear one and see if it helps, and yeah i gave you 1-2 3-4 i think... it was two attached so i don't remember, it was really like 4-5 months ago lol...
__________________
die in a dick fire noob is offline   Reply With Quote
Old 09-26-2009, 04:16 PM   #11
onefst91hatch
...
 
onefst91hatch's Avatar
 
Join Date: Jun 2006
Location: Surprise/Glendale
Posts: 5,536
iTrader: (23)
tghe engine harness will not work.

88 only
89 only
90-91

and it has to be same model too. dx hf si ex auto or manual are all different with different plugs. good luck man. and your trans sounds like a bad/bent fork to me. but you could also check all your linkage and deffinately replace worn out mounts. haveing bad mounts can fuck up alot of other stuff as well.
__________________

CHRIS FAB
onefst91hatch is offline   Reply With Quote
Old 09-27-2009, 10:29 AM   #12
Ludehrt
 
Join Date: Sep 2007
Location: Mesa
Posts: 39
iTrader: (0)
I would also do the simple things first such as making sure your clutch cable is adjusted.





Enkei RPF1's For Sale 15x7 +35
Ludehrt is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump



Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.
ŠAZHT.net 2004-2018
Design by HTWoRKS